Remote Control; Battery Installation - Coby DVD968 Instruction Manual

DVD968 at a Glance

Remote Control

The remote control transmits a directional infrared beam. Be sure to aim
the remote control directly at the infrared remote sensor during opera-
tion. The sensor may not be able to receive signals properly if the sensor
is covered, if there is a large object between the remote control and the
sensor, or if it is exposed to direct sunlight or a strong artificial light (e.g.,
fluorescent or strobe lights). If possible, change the position of the light
source or reposition the unit to avoid direct lighting.
To use the remote, point it at the remote sensor of the player. Operate
the remote within 15 feet of the sensor and at an angle of ± 60 degrees.

Battery Installation

1. Remove the battery compartment cover located on the rear of the
remote control.
2. Insert batteries, making sure to match their polarities (+/-) to the
markings on the inside of the compartment.
3. Replace the cover.
Batteries in the remote will last for approximately 1 year. Replace
the batteries if the remote control does not work. Always dispose
of batteries according to your local municipal regulations.
The batteries used in the remote control may present a fire or
chemical burn if mistreated. Do not recharge, disassemble, in-
cinerate, or heat the battery (~212°F). Do not mix old with new
batteries, or different types of batteries. Remove the batteries
from the remote if it will not be used for a long period of time.
Keep batteries away from children.
Page 12 Coby Electronics Corporation