Receiver Audio Distortion And Hum And Noise (Requires Audio Connections) - HP 8924E Introduction Manual

Chapter 4, Mobile Station Analog Tests

Receiver Audio Distortion and Hum and Noise (requires audio connections)

Receiver Audio Distortion and Hum and Noise (requires audio
connections)
1. Set up the receiver distortion measurement.
1. Press the ANLG MEAS key.
2. Set the FM level field to 8 kHz.
3. Set the AF Anl In field to Audio In.
4. Set the Filter 1 field to C MESSAGE.
2. Make the receiver distortion measurement.
1. Select Distn in the field shown.
The value displayed should be less than 5%
78