Advertisement
Cleaning the Earphone Nozzle
If you notice a change in sound quality, remove the sleeve and check the nozzle
of your earphone. If nozzle is blocked, clear obstruction by
using wire loop end of cleaning tool.
Cleaning
Tool
Wire Loop
Caution: When cleaning, do not force any object through the earphone nozzle!
This will damage the earphone sound filter.
Warning: The cleaning tool is only to be used to clean the earphones.
Any other use, such as using the tool to clean ears, could result in injury.
Accessories
• Earphone Sleeves
• Replacement Cables
• Carrying Cases
Maintenance
• Careful maintenance ensures a tight seal between the sleeve and nozzle, improving
sound quality and product safety.
• Keep the earphones and sleeves as clean and dry as possible.
• To clean sleeves, remove them from earphones, gently rinse in warm water and air
dry. Foam sleeves require a longer drying time. Inspect for damage and replace if
necessary. Ear sleeves must be completely dry before reusing.
• Wipe the earphones and sleeves with mild antiseptic to avoid infections. Do not use
alcohol-based disinfectants.
• Do not expose earphones to extreme temperatures.
• Replace the sleeves if they do not fit properly.
• Do not attempt to modify this product. Doing so will void the warranty and could result in
personal injury and/or product failure.
• Note: The cable connectors to the earphones may collect debris or other deposits that
can affect audio quality. If this happens, disconnect the cables and clean them using a
dry cotton swab.
WARNING: This product contains a chemical known to the State of California to cause
cancer and birth defects or other reproductive harm.
• Music Phone Accessory Cables
• Volume Control
• Adapters
Technical Specifications
Transducer type
Single High-Definition MicroDriver
Sensitivity (at 1khz)
Impedance (at 1kHz)
Frequency Range
Input connector
Net weight
Operational temperature
Storage temperature
CERTIFICATION
Eligible to bear CE Marking. Conforms to EMC Directive 2004/108/EC. Meets applicable
tests and performance criteria in European Standard EN55103 (1996) parts 1 and 2, for
residential (E1) and light industrial (E2) environments. The Declaration of Conformity can
be obtained from the address below.
Shure Europe GmbH
Authorized European representative:
Shure Europe GmbH
Headquarters Europe, Middle East & Africa
Department: EMEA Approval
Wannenacker Str. 28
D-74078 Heilbronn, Germany
Phone: +49 7131 72 14 0
Fax: +49 7131 72 14 14
Email: EMEAsupport@shure.de
3
SE315
116 dB SPL/mW
27 W
22 Hz - 18.5 kHz
3.5mm (1/8 in.) gold-plated stereo plug
30 g (1 oz.)
-18° C to 57° C (0° F to 135° F)
-29° C to 74° C (-20° F to 165° F)
Advertisement
