Shure Sound Isolating SE310 User Manual

Sound Isolating™ Earphones
Featuring sound isolating
design and Tuned BassPort
enhanced Hi-Definition
MicroSpeakers, the Shure
SE310 delivers extended
range audio and enhanced
bass. An ideal personal
listening device upgrade, the
stylish Shure SE310 includes
a carrying case, modular
cable, interchangeable
Sound Isolating™ sleeves
and adapters—providing
©2006, Shure Incorporated
27EN3244 (Rev. 2)
REMOVING THE EARPHONES
Grasp the body of the earphone and gently twist to remove.
Note: Do not pull on cable to remove the earphone.
SE310
WEARING THE EARPHONES
Three suggested methods for wearing the earphones are illustrated below.
Over the ear
in back
a comfortable,
personalized fit and
maximum portability
Tighten the cable and take up slack by raising the cable sleeve.
Printed in U.S.A.
CHOOSING AN EARPHONE SLEEVE
Your earphones come with a selection of sleeves. Make sure the sleeve you
choose is easy to insert into your ear, fits comfortably, and is easy to remove
from your ear.
Soft Flex Sleeves
In small, medium, and large sizes.
Made from pliable rubber.
Soft Foam Sleeves
When using the foam sleeves, compress the sleeve between your
fingers before inserting it into the ear canal. Hold the earphone in
place for about ten seconds while the foam expands and creates
a tight seal.
Triple-Flange Sleeves
If desired, the sleeve stem may be shortened. Use sharp scissors
to carefully trim the stem to the desired length.
Note: carefully slide sleeve over earphone nozzle barb for a secure grip.
Over the ear
Cable
in front
Sleeve
Straight down
in front
INSERTING THE EARPHONES
If the earphone seems to be lacking in low frequency response (bass), check
the tightness of the seal between the earphone and your ear, or try one of the
other sleeve options.
Warning: Do not push the earphone sleeve beyond the ear canal opening.
To replace sleeve, carefully remove old one and slide new sleeve over nozzle barb. If any
part of the nozzle is exposed, sleeve is not properly installed. Replace sleeves if they do
not grip the nozzle tightly
Nozzle Barb Sleeve Sleeve Over Barb
CLEANING THE EARPHONE NOZZLE
If you notice a change in sound quality, remove the sleeve and check
the nozzle of your earphone. If nozzle is blocked, clear obstruction
by using wire loop end of cleaning tool.
Wire Loop
Nozzle
Cleaning
Tool
When cleaning, do not force any object through the earphone nozzle!
This will damage the earphone sound filter.