Dropping Or Raising The Feed Dog; Needle Stop Position Setting - Janome M50QDC Instruction Book

q
View from the rear
w
q
q
w

Dropping or Raising the Feed Dog

w
The drop feed lever is located underneath the free arm
bed on the back of the machine.
To drop the feed dog, push the lever in the direction of
the arrow q.
To raise the feed dog, push the lever in the direction
of the arrow w, as illustrated, and turn the handwheel
toward you.
The feed dog must be up for normal sewing.
NOTE:
Set the stitch length value at the minimum when
lowering the feed dog.

Needle Stop Position Setting

You can set the needle stop position to up or down when
the machine stops.
To enter the needle stop position setting mode, turn the
power off.
Press and hold the needle up/down button q, and turn
the power switch on. Hold then needle up/down button
until the needle stop position setting screen appears as
shown.
The default setting is down and "dn" sign appears on the
screen.
Press the needle up/down button q.
The "uP" sign appears and the needle stop position is set
to up.
Press the START/STOP button w to apply the setting.
13