General Operations; Signal Sources - Telefunken TF-LED24S01T2 Instruction Manual

.
• Use two AAA batteries for the RC. The RC
should be pointed at remote sensor within 8
meters and within 30 degrees at the left or the
right side.
• Take the battery out of the RC if it is not
used for a long time.
• Do not mix new and used batteries or
different types of batteries. Weak batteries can
leak and severely damage the RC.
• Do not expose the RC to shock, liquids,
and do not place it in an area with high
humidity.
CAUTION!
Incorrect installation of the batteries may
lead to an explosion.
Please replace used batteries with the
batteries of the same or comparable type.

General operations

• Press button on the unit or on the RC
to switch on the power. Press POWER button
again to switch the unit off and go the the
stand-by mode. To completely power off the unit
unplug the power cable from the outlet.
• Press VOL- button repeatedly to decrease
the volume; press VOL+ button repeatedly
to increase the volume.
• Press SLEEP button repeatedly to set the
sleep time.
• Press DTV button to switch between
analog and digital TV.
• Press EPG to launch the Electronic
Program Guide (EPG).
• Press T.SHIFT to enable the Time
Shift function for digital TV.
• Press SUBTITLE to show and set the
language of a current DTV channel.
• Press REC to begin recording of current
playback in PVR mode.
• Press button on the RC to select
from the present channel and the previously
displayed channel.
• Press ASPECT button repeatedly to select
a screen display size from the available list:
4:3/16:9/Zoom1/Zoom2/Panorama. Available
aspects may differ for different signal sources.
• Press MUTE button to cut off sound, press
this button again or adjust volume to resume
8
sound.
• Press TV/RADIO button to switch between
TV and radio modes when watching channels.
• Select the TV function mode. Press
CH-/CH+ buttons to select previous or next
channels; or press number buttons to enter a
channel number directly.
• Press P.MODE button repeatedly to cycle
through the available video picture modes.
• Press S.MODE button repeatedly to cycle
through the available sound modes.
• Press DISPLAY button to display the
preset TV channel play information.
• Press FREEZE button to freeze the
picture on or off.
• Press FAV button to show the favourite
channel list.
• Press NICAM/A2 button in TV mode repeatedly
to switch between various Nicam sound modes
(can be unavailable for some channels).

Signal sources

Press SOURCE button, then press DOWN/UP
cursor buttons on the RC or CH+/CH- buttons
on the panel to select a source from available
source list: DTV - ATV - AV - PC - SCART -
COMPONENT - HDMI - MEDIA. Press ENTER
button on the RC or MENU button on the panel
to confirm. Press EXIT to exit.
TELETEXT operations (option)
• Select the TV source mode. Then press
CH-/CH+ buttons to select TV channel in order
to pick up the picture signal of Teletext.
• Teletext button functions are as follows:
TEXT: Press this button to enter into Teletext
mode. Follow the guides on screen and use
the color buttons to navigate the Teletext.
Red/Green/Yellow/Blue buttons: Press
these 4 color buttons to access directly to
corresponding color page displayed at the
lower parts of teletext screen.
REVEAL: press this button to display and
reveal hidden information.
S.PAGE: press to access a subpage of
the Teletext.
HOLD: press this button to stop the move
to the next page. Press this button again to
cancel operation.
INDEX: press this button to go to the
index page.
SIZE: press to adjust the size of Teletext.
Operation
8