Table of Contents
Advertisement
HEAVY WOODEN WALL
ABSORBING
MATERIAL
VIBRATION
ISOLATORS
f ~ 2-8 Hz
Figure 6. Flush mounting the speaker in
a wall constructed of wood
Testing Mode
Once on, when the power button is
pressed for a long time, the RAM-L enters
a mode for system testing. This special
mode is intended for system debugging
and testing. When the RAM-L is turned
off, the special mode is reset. Upon
restarting the RAM-L the current standard
settings stored by GLM software are
restored.
Test mode selection blinks the power
button light (see Table 2). A special mode
is activated by a long press on the power
button. In a special mode the power button
light remains on but blinks off 1-4 times
indicating the mode currently selected.
The testing modes are not intended for
continued operation. Use GLM software to
set up permanent settings for 1238DF.
Safety Considerations
The 1238DF has been designed in
accordance with international safety
standards. To ensure continued safe
operation and to maintain the monitor
under safe operating conditions, the
following warnings and precautions must
be observed:
1.
Servicing and adjustment must only
be performed by qualified service
CONCRETE WALL
SAND
BAGS
VIBRATION
ISOLATORS
f ~ 2-8 Hz
Figure 7. Flush mounting the speaker in
a wall constructed of concrete
personnel. The monitor enclosure or
the amplifier enclosure must not be
opened.
2.
Do not use this product with a
mains cable with no protective earth
conductor, or a mains connection
without the protective earth contact,
as this may lead to personal injury.
3.
To prevent fire or electric shock,
do not expose the unit to water or
moisture.
4.
Do not place any objects filled with
liquid, such as vases or water pipes
on the amplifier or near it.
5.
Note that the amplifier is not
completely disconnected from the AC
mains service unless the mains power
cord is removed from the amplifier
or the mains outlet. Easy access to
either end of the power cord must be
ensured at all times.
6.
Free flow of air around the amplifier
is necessary to maintain sufficient
cooling. Do not obstruct airflow
around the amplifier.
WARNING!
The Genelec 1238DF monitor is capable of
producing sound pressure levels in excess
of 85 dB, which may cause permanent
hearing damage.
MULTI-LAYERED WALL
(WOOD, CONCRETE, BRICKS)
CONCRETE
STRUCTURE
VIBRATION
ISOLATORS
f ~ 2-8 Hz
Figure 8. Flush mounting the speaker
in a wall constructed of a combination
of materials.
SPEAKER
RUBBER GASKET
(5-10 mm / ¼-½")
FACING PANEL
FIXED TO THE WALL
(50-100 mm / 2-4")
WALL
Figure 9. Covering the gap between
the wall and the monitor enclosure.
Symbols
WEEE Directive 2012/19/EU
Power/standby switch
Maintenance
No user serviceable parts are to be found
within the monitor enclosure or the RAM-L
amplifier unit. Any maintenance or repair of
the monitor should only be undertaken by
qualified service personnel.
Guarantee
The Genelec 1238DF is supplied with a
two year guarantee against manufacturing
faults or defects that might alter the
Advertisement
Table of Contents
