Table of Contents
Advertisement
Figure 6. Pull out the left side of the
amplifier and detach the flat cable from
the enclosure.
Figure 7. Remove the flat cable cover
plate and detach the flat cable connec-
tor. Reattach the cover plate.
Figure 8. Remove the front mounting
ears.
crete) wall structure, the space around the
cabinet should be filled with absorbent min-
eral wool or sand bags (see Figure 12).
Ensure that the cabinet is flush with the
surface of the wall. If a decorative cloth
frame is used the edges adjacent to the
monitors must be less than 20 mm (3/4 in)
deep. The cloth must be acoustically trans-
parent. Genelec-approved cloth grilles are
available.
Testing Mode
Once on, when the power button is pressed
for a long time, the RAM-L enters a mode
for system testing. This special mode is
intended for system debugging and testing.
When the RAM-L is turned off, the special
mode is reset. Upon restarting the RAM-L
the current standard settings stored by GLM
software are restored.
Test mode selection blinks the power
button light (see Table 2). A special mode
is activated by a long press on the power
button. In a special mode the power button
light remains on but blinks off 1-4 times indi-
cating the mode currently selected.
The testing modes are not intended for
continued operation. Use GLM software to
set up permanent settings for 1237A and
1238A.
Figure 9. Attach the
angled rack mount ears.
Figure 10. Attach the front
plate.
Safety Considerations
The 1237A and 1238A have been designed
in accordance with international safety
standards. To ensure continued safe opera-
tion and to maintain the monitor under safe
operating conditions, the following warnings
and precautions must be observed:
1.
Servicing and adjustment must only
be performed by qualified service
personnel. The monitor enclosure or
the amplifier enclosure must not be
opened.
2.
Do not use this product with a mains
cable with no protective earth conduc-
tor, or a mains connection without the
protective earth contact, as this may
lead to personal injury.
3.
To prevent fire or electric shock, do not
expose the unit to water or moisture.
4.
Do not place any objects filled with
liquid, such as vases or water pipes on
the monitor or near it.
5.
Note that the amplifier is not completely
disconnected from the AC mains ser-
vice unless the mains power cord is
removed from the amplifier or the mains
outlet.
6.
Free flow of air behind the monitor is
Advertisement
Table of Contents
