Installing The Transceiver - Kenwood TK-690 Series Instruction Manual

■

Installing the Transceiver

FOR PASSENGER SAFETY, INSTALL THE TRANSCEIVER SECURELY, USING THE
WARNING!
SUPPLIED MOUNTING BRACKET, SO THE TRANSCEIVER WILL NOT BREAK LOOSE IN THE
EVENT OF A COLLISION.
1 Mark the position of the holes in the dash by using the mounting bracket
as a template. Drill the holes, then attach the mounting bracket using the
supplied 5 x 16 mm screws.
• Be sure to mount the transceiver in a location where the controls will be within
easy reach of the user, and where there is sufficient space at the rear of the
transceiver for cable connections.
2 Connect the antenna and the supplied power cable to the transceiver.
3 Slide the transceiver into the mounting bracket and secure it using the
supplied hex-headed screws.
4 Mount the microphone hanger, using the supplied 4 x 16 mm screws, in a
location where it will be within easy reach of the user.
• The microphone and microphone cable should be mounted in a place where
they will not interfere with the safe operation of the vehicle.
5 Connect one plug of the microphone cable to the jack on the base of the
microphone, and the other plug to the microphone jack on the front panel
of the transceiver. Place the microphone on the hanger.
Microphone
hanger
Power input
connector
4
Mounting bracket
Antenna
connector
Power cable
Microphone
Transceiver
Fuse holder
Red wire
Black wire
Microphone cable
Hex headed
screw
Fuse
Battery