Full-Featured Front Panel (Kch-11) - Kenwood TK-690 Series Instruction Manual

■

Full-featured Front Panel (KCH-11)

q q q q q
POWER
o o o o o
TX BUSY
!0 !0 !0 !0 !0
q q q q q POWER switch
Press to switch the power ON (or OFF).
w w w w w GRP (Group) keys
Press GRP Up to increase the group selection by one step. Press GRP
Down to decrease the group selection by one step. (See page 11 for
other programmable functions for these keys.)
e e e e e MON (Monitor) key
Press to cancel QT, DQT, 2Tone, and DTMF signaling squelch (default
setting). Press and hold for 2 seconds to hear background noise (unmute
the audio). (See page 11 for other programmable functions for this key.)
r r r r r SCN (Scan) key
Press to start (or stop) the scanning sequence (default setting). (See
page 11 for other programmable functions for this key.)
t t t t t PF6 key
y y y y y PF7 key
u u u u u PF8 key
i i i i i PF9 key
o o o o o TX, BUSY indicators
The TX (red) indicator lights while transmitting. The BUSY (green)
indicator lights while the selected channel is in use.
!0 !0 !0 !0 !0 Microphone connector
Insert the microphone plug into this connector and secure it using the
attached screw. To remove the microphone, release the screw, then turn
the connector clockwise until it becomes free.
!1 !1 !1 !1 !1 VOL (Volume) control
Turn clockwise to increase the volume, and counterclockwise to decrease
it.
w w w w w
CALL MON
GRP
VOL
!1 !1 !1 !1 !1
Press these PF (programmable function) keys to activate
their programmable functions {page 11}. The default is set
as No Function.
SCAN SP OPT A B C
CH
!2 !2 !2 !2 !2 !3 !3 !3 !3 !3 !4 !4 !4 !4 !4
e e e e e r r r r r t t t t t
MON
OST
SCN
!6 !6 !6 !6 !6
!5 !5 !5 !5 !5
y y y y y
u u u u u
i i i i i
!7 !7 !7 !7 !7
7