Table of Contents
Advertisement
General Installation Process
5
Install the Clip on the Remote Mount
Board
A
Ground yourself, and make sure that the system is grounded.
B
Place the clip and the remote mount board module front-side-up on
a flat, clean, static-free surface.
C
Hold the clip so the screw holes on the clip line up with the screw
holes on the remote mount board, as shown in the following figure.
A
Clip
D
Secure the clip to the remote mount board in three screw holes with
the screws and the nuts.
E
The screws thread through the front of the clip and the remote
mount board.
Center the screwdriver carefully to avoid stripping the screw heads.
Do not over-tighten the screws.
A
A
6
Attach the Super Capacitor Pack
Module to the Clip
A
Ground yourself, and make sure that the system is grounded.
B
Place the Super Capacitor Pack module and the clip front-side-up
on a flat, clean, static-free surface.
C
Press the Super Capacitor Pack module into the clip until the
module clicks firmly into place, as shown in the following figure.
A
Super Capacitor Pack
module
3
Clip
Advertisement
Table of Contents
