Timing Of Replacing The Lamp - BenQ SP830 User Manual

Timing of replacing the lamp

When the Lamp indicator lights up red or a message appears suggesting it is time to replace
the lamp, please install a new lamp or consult your dealer. An old lamp may cause a
malfunction in the projector and in some instances the lamp may explode.
The Lamp indicator light and Temperature warning light will light up if the lamp becomes
too hot. Turn the power off and let the projector cool for 45 minutes. If the Lamp or Temp
indicator still lights up after turning the power back on, please contact your dealer. See
"Indicators" on page 73
The following Lamp warning displays will remind you to change the lamp.
Status
The lamp has been in operation for 3000 hours.
Install a new lamp for optimal performance. If the
projector is normally run with Eco. selected (See
"Getting to know the lamp hour" on page
may continue to operate the projector until the
3950 hour lamp warning appears.
Press ENTER to dismiss the message.
The lamp has been in operation for 3950 hours. It
is strongly recommended that you replace the lamp
at this age. The lamp is a consumable item. The
lamp brightness diminishes with use. This is
normal lamp behavior. You can replace the lamp
whenever you notice that the brightness level has
significantly diminished. If the lamp is not
replaced beforehand, it should be replaced after
3950 hours usage.
Press ENTER to dismiss the message.
The lamp has been in operation for 4000 hours.
The lamp MUST be replaced before the projector
will operate normally.
Press ENTER to dismiss the message.
for details.
68), you
Message
WARNING
NOTICE: Order replacement lamp
Lamp > 3000hrs
Projector will stop at 4000hrs
OK
WARNING
NOTICE: Order replacement lamp
Lamp > 3950hrs
Projector will stop at 4000hrs
OK
WARNING
NOTICE: Replace lamp now
Lamp > 4000hrs
Lamp-usage time exceeded
Replace lamp (refer to User Manual)
OK
Maintenance 69