Installation; Hardware Installation - BenQ FP547 User Manual

Installation

Hardware Installation

A. Make sure that the computer and monitor's power are both turned off. Please follow
the steps to install your LCD monitor.
Exit Enter
Place the monitor face down on a soft surface. Hold the back of the monitor with one hand.
Using the other hand, press the release button on the base and push outward in the direction of
the arrow to detach the base extension.
B. Connect the signal cable to the VGA output of the graphics card on the computer.
C.Connect the power cord at the back of the monitor to an AC power socket. Please
make sure that the socket is not blocked or covered, so you can disconnect the unit
from AC supply if you need to. Your monitor is equipped with an automatic power sup-
ply for a voltage range from 100 to 240 Volt at a frequency of 50 to 60 Hz. Be sure that
your local power is within the supported range. If you are unsure, ask your electricity
supplier.
Power Cord
BenQ LCD Color Monitor User's Guide
Place the arrow on the base and the front side
of the monitor in corresponding direction. The
arrow on the base indicates the front of the
base. Place the monitor into the base until it
locks into place. There will be a clicking sound.
Signal Cable
English 6