Back Focus Adjustment; Replacement Of The Mounting Cradle - Bosch VEN-650 Series Installation Manual

EX65 Explosion-Protected Camera
4. Complete the back focus adjustments as described in section 10.5. Attach all of the
connections at the back of the camera at the same connection points as when removed.
5. Reinstall the sliding tray back into the housing as shown in steps 9 - 12 of Configuration,
page 24.
10.4

Back Focus Adjustment

To optimize picture sharpness in both bright and low-level lighting, adjust the back focus. Use
the camera's unique Lens Wizard. This ensures that the object of interest always remains in
focus, even when focusing at the maximum lens iris opening (for example, at night).– When
back focusing varifocal lenses, adjust to obtain a sharp picture in both wide-angle and tele
positions for both far and near focus.– When back focusing zoom lenses, ensure that the
object of interest remains in focus throughout the entire zoom range of the lens. To adjust
back focus:
1. Open the side door panel at the side of the camera.
2. Unlock the back focus locking button.
3. Press and hold the center key for more than two (2) seconds until the Install menu
appears.
4. Select Lens Wizard and move the cursor to the Set Back Focus Now option.
5. Turn the back focus adjustment as necessary.
6. Lock the back focus locking button.
7. Press and hold the center key for more than two (2) seconds until all menus disappear.
8. Close the side door panel.
10.5

Replacement of the Mounting Cradle

1. Disconnect power from the unit and, optionally, remove all connections.
Bosch Security Systems, Inc. Installation Manual
Available from A1 Security Cameras
www.a1securitycameras.com email: sales@a1securitycameras.com
Maintenance | en 43
2016.03 | 1.0 | F.01U.318.222