Windscreen Holder Installation - Binatone X430 User Manual

QUICK START GUIDE

Windscreen Holder Installation

The car mount has a suction pad that fits to the windscreen or a flat area on the
dashboard.
A. Fitting to windscreen
Pull the lever away from the suction pad. Place the pad on the widescreen and push
the lever towards the pad until it clicks into place.
B. Fitting the holding bracket
It is best to fit this to the unit before it is attached to the windscreen.
With the lever facing down, slide the bracket onto the four securing lugs on the end
of the car mount, making sure that the top of the bracket is no located on the same
side as the lever.
C. Fitting the Unit
Slide the unit into the bottom of the bracket and carefully push the unit up until it
clicks into place at the top.
To remove the unit from the car mount; Press and lift the tab at the top of the bracket
then pull the unit forward and up out of the bottom of the bracket.
To remove the Car mount from the windscreen; Lift the lever away from the
windscreen, then gentle pull the tab on the suction cup to release the suction as you
pull the mount away from the windscreen.
8 Binatone Help Line: 0845 345 9677 (for UK only. Local Call rate)
PDF 文件使用 "pdfFactory Pro" 试用版本创建 www.fineprint.cn