LG LT-E1860RJ Service Manual page 27

7. Installation of Decorative Panel
The decorative panel has its installation
direction.
1. Temporarily fix two decorative panel fixing screws (hexagon M5 screw) on the unit body. (Tighten by amount
10mm in length.)
The fixing screws (hexagon M5 screw) are included the indoor unit box.
2. Remove the air inlet grille from the decorative panel. (Remove the hook for the air inlet grille cord.)
3. Hook the decorative panel key hole (
the screws reach the key hole edge.
4. Retighten completely two temporarily fixed screws and other two screws. (Total 4 screws)
5. Connect the louver motor connector and display connector.
6. After tightening these screws, install the air inlet grille (including the air filter).
Air conditioner unit
Decorative panel fixing screws
(hexagon M5 screws)
Temporally fitting at 2 places
(Tightening about 10mm)
Inlet Grille Inlet Grille
Louver motor
Decorative panel
) on the screws fixed in step above, and slide the panel so that
Key holes
Decorative panel fixing screws
(Hexagon M5 screw)
Inlet Grille Inlet Grille Inlet Grille
Before installing the decorative panel,
always remove the paper template.
Piping side
–27–
Control box cover
Display
Lead wire for
louver motor and
display