Entering The Admin Mode; Exiting The Admin Mode - Apricorn Aegis Padlock A25-PL128 250GB User Manual

Entering the Admin Mode

Note: The Aegis Padlock cannot be recognized by the operating system in the
Admin Mode.
To enter the Admin Mode, do the following:
1.
Attach the USB cable to an available USB port on your computer. The Aegis
Padlock goes into the Standby Mode, and the indicator light turns red.
2.
Press and hold
indicates that you can enter the Admin Password.
3.
Enter the Admin Password and press
123456. The Secure Hard Drive is in Admin Mode when the indicator light has
changed to blue.

Exiting the Admin Mode

To exit the Admin Mode, press the "Cancel" button in the Admin Mode until the
indicator light turns red. This indicates that you are in the Standby Mode.
Note: If the indicator light flashes red for a few seconds, indicating the
Aegis Padlock has returned to the Standby Mode, go back to Step 2. This
is due to one of the following conditions:
•
You entered an incorrect Admin Password in Step 3.
•
No activity was detected within two minutes in the Admin Mode.
+ 0 for five seconds until the indicator light flashes red. This
www.apricorn.com
. The default Admin Password is
9