Table of Contents
Advertisement
USING THE PROJECTOR
Powering on / off the projector
Powering on
1.
Securely connect the power lead and signal/source cable. When connected, the On/Standby LED will
turn red.
2.
Turn on the projector by pressing the " " either on the projector keypad or the remote control.
3.
A start up screen will display in approximately 10 seconds and the On/Standby LED will be flashing
blue.
Notee:
The first time the projector is turned on, you will be prompted to select the preferred language, projection
orientation, and other settings.
Powering off
1.
Turn off the projector by pressing the " " either on the projector keypad or the remote control.
2.
The following message will be displayed:
3.
Press the " " again to confirm, otherwise the message will disappear after 15 seconds. When you
press the " " button for the second time, the projector will shut down.
4.
The cooling fans will continue to operate for about 10 seconds for the cooling cycle and the On/
Standby LED will flash blue. When the On/Standby LED turns solid red, this indicates the projector has
entered standby mode. If you wish to turn the projector back on, you must wait until the cooling cycle
has finished and the projector has entered standby mode. When the projector is in standby mode,
simply press the " " button again to turn on the projector.
5.
Disconnect the power lead from the electrical outlet and the projector.
Notee:
It is not recommended that the projector is turned on immediately, right after a power off procedure.
or
Power Off
Power Off?
Press power key again.
23
English
Advertisement
Table of Contents
