Doors; Removing The Left (Freezer) Door; Removing The Right (Refrigerator) Door - LG LSXC22386 Series Owner's Manual

Side by side refrigerator
Hide thumbs Also See for LSXC22386 Series:
Table of Contents

Advertisement

Removing and replacing
refrigerator doors
WARNING
Excessive Weight Hazard:
• Use two or more people to remove and install
the refrigerator doors. Failure to do so can
result in back or other injury.
Electrical Shock Hazard
• Disconnect the electrical supply to the
refrigerator before installing. Failure to do so
could result in serious injury or death.
• Do not put hands, feet or other objects into
the air vents or bottom of the refrigerator. You
may be injured or receive an electrical shock.

Removing the Left (Freezer) Door

with Water Line Connection
1. Disconnect the 2 water line connections,
located on the back of the refrigerator. Hold
the water supply connection and gently
push the collet to detach the water supply
line as shown.
CAUTION
Before you start, take out the food and
remove the door trays.
2. Open the door. Remove the top hinge cover
screw.
3. Use a flat-blade screwdriver to pry back the
hooks (not shown) of the hinge cover from the
top of the refrigerator cabinet. Lift up the cover.
4. Disconnect all the wire harnesses and remove
the hinge cover.
5. Pull out the water supply lines.
6. Unscrew the ground wire.
CAUTION
When lifting the hinge free of the latch,
be careful that the door does not fall
forward.
7. Rotate the hinge lever counterclockwise. Lift
the upper hinge free of the hinge lever latch.
INSTALLATION
8. Lift the door from the lower hinge pin and
place it, inside facing up, on a non-scratching
surface.
Removing the right (refrigerator)
door
1. Open the door. Remove the screw from the
cover of the upper hinge (1). Lift the lid (2).
2. Use a flat screwdriver to make lever and lift
the hooks (not seen in the image) located at
the bottom front of the lid. Lift the lid.
3. Turn the hinge lever (3) on the
clockwise. Lift the upper hinge (4) separated
from the bra of the hinge lever (5).
4. Place the door, with the inner part up, on a
surface that does not scratch.
CAUTION
When you lift the hinge separate from
the clamp, be careful that the Door does
not fall forward.
• Lift the door from the power plug
middle hinge and remove the door.
• Place the door, with the inner part up,
on a surface that does not scratch.
5. Raise the door from the bottom pin of
The hinge.
Bottom hinge
CAUTION
• When releasing the handle hinge, be
careful that the door does not fall forward.
• Place the door, the inside looking
outward, on a scratched surface, have
Be careful not to damage the water lines.
13
(1)
(2)
(3)
(4)
(5)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents