Closing And Aligning The Doors - LG LFC23760ST/03 Service Manual

3-10 CLOSING AND ALIGNING THE DOORS

Closing the Doors
Your refrigerator has two front leveling screws, one on the
right and one on the left. If your refrigerator seems
unstable or if you would like the doors to close more easily,
simply adjust the inclination of the refrigerator by following
the instructions below:
1. Plug the refrigerator into a 3 prong grounded outlet.
Move the refrigerator into its final position.
2. Remove the base grille (Refer to the section on
"Installation of Base Grille").
3.
Use a flat head screwdriver to adjust the leveling
screws, turning clockwise to raise the side of the
refrigerator and counter-clockwise to lower it. It may
take several turns to adjust it to the inclination you
would like.
NOTE: Having someone push against the top of the
refrigerator takes some weight off the leveling screws.
This will make it easier to adjust the screws.
4. Open both doors again and check to make sure that
they close easily. If not, slightly tilt the refrigerator
further back by turning both leveling screws clockwise.
It may take several more turns. Make sure that you
turn both leveling screws the same amount.
5. Ensure that the refrigerator is even by using a level.
6. Replace the base grille.
Aligning the Doors
If the spacing between the doors is uneven, follow the
instructions below to align them:
With one hand, lift up the door you want to raise at
1.
middle hinge.
2. With other hand, use pliers to insert snap ring as
shown.
3. Insert additional snap rings until the doors are aligned.
(Three snap rings are provided per unit.)
- 16 -