Table of Contents
Advertisement
3D Refresh Rate
• Auto
• 100Hz
• 120Hz
Resolution
Enhancer
• Off
• Mid
• Max
Side Panel
• Off
• Low
• Mid
• High
16:9 Overscan
• Off
• On
AV Colour System
• Auto
• PAL
• SECAM
• M.NTSC
• NTSC
Colour Matrix
• SD
• HD
DVI Input Setting
• Normal
• Full
Pixel Orbiter
• Auto
• On
Scrolling Bar
Reset to Defaults
∗ 1 : PC input mode only
Changes the setting of the high-speed motion picture response
Enhances the picture resolution to make the image sharper
•
This function is available for SD (Standard definition) signal.
•
As for HD (High definition) signal, this function is available when aspect
mode is set to [16:9] ([16:9 Overscan] is set to [On]), [4:3 Full] or
[Zoom].
•
Not valid on VIERA Connect and Media Player
Increases the brightness of the side panel
•
The recommended setting is [High] to prevent panel "image retention".
[On]: Default - Image is overscanned by ~5% beyond the edge of the
screen to hide edge video noise
[Off]: Displays image in its original size including edge video noise such
as lines, dashes, dots etc.
•
Applicable for video signals when TV aspect is set to [16:9]
•
Memorised separately for SD and HD channels / signals
Selects optimum colour system based on video signals in AV mode
Available only with 480p or 576p input on video signals in a natural
colour from digital equipment connected to AV1 component or HDMI1 /
HDMI2 / HDMI3 / HDMI4 terminals. Select [SD] or [HD] to adjust suitable
colour parameters for [SD] (standard definition) or [HD] (high definition)
•
[SD]: Input signal is a normal TV system
•
[HD]: Input signal is a high definition system
Changes the black level in the image for HDMI input mode with DVI input
signal manually
•
When the DVI input signal from the external equipment, especially from
PC, is displayed, the black level may not be suitable. In this case, select
[Full].
•
The black level for HDMI input signal will be adjusted automatically.
•
For HDMI input mode with DVI input signal only
Selects the mode for wobbling of the image to prevent panel
"image retention"
[Auto]: Automatically works only for the appropriate images and you
rarely recognise the wobbling.
Scrolls the vertical bar to prevent panel "image retention"
•
Press the OK button to start scrolling and press any buttons (except
Standby) to exit this mode.
Press the OK button to reset the present Picture Viewing Mode of the
selected input to the default settings
37
Advertisement
Table of Contents
