Connection - Toshiba TDP-SP1U Owner's Manual

Connection

Before connection
• Read the owner's manual of the device you are connecting to the projector.
• Some computers cannot be used with or connected to this projector.
Check for an RGB output terminal, supported signal
• Turn off the power of both devices before connecting.
• The figure below shows sample connections. This does not mean that all of these devices
can or must be connected simultaneously.
To video output
Video cable
(not supplied)
RGB cable
(supplied)
Computer
To RGB output
Notes
• Moving pictures played back on computers using DVD software may appear unnatural
when projected with this projector. However, it is not a malfunction of the projector.
• When an AUDIO OUT terminal is connected, sound is not output from the projector
speaker.
• Output volume of AUDIO OUT terminal can be adjusted by the VOL+/- button.
• The MONITOR OUT terminal outputs analog RGB signals or component video signals
(Y/P /P ) from the COMPUTER IN terminals.
B R
• A computer monitor usually cannot accept Y/P
To audio output
Audio cable
(not supplied)
S-Video cable
(not supplied)
To S-video output
, etc.
p.43
Monitor Computer (for control)
Audio cable
(not supplied)
To audio input
/P signals correctly.
B R
23
p.45
To RS-232C
terminal
Control cable