Led Indicators - SMC Networks SMCWBR14-3GN User Manual

1
Introduction

LED Indicators

The wireless AP/Router includes nine status LED indicators, as described in the
following figure and table.
LAN Link/Activity
WAN Link/Activity
Power
802.11n Link/Activity
WPS Link/Activity
LED Status
POWER On Green
WAN On/Flashing Green
Off
LAN (4 LEDs) On/Flashing Green
Off
WLAN On/Flashing Green
Off
WPS On (for 10 seconds) Indicates the WPS authentication of a device has been successfully
Fast Flashing Green Indicates the WPS authentication of a client device is in progress.
Slow Flashing Green
(for 10 seconds)*
Off
3G Link On
Fast Flashing Green Indicates that the PIN code has failed.
Slow Flashing Green Indicates that the 3G/3.5G USB modem is in the process of connecting.
Off
*
Slow flashing is an on-off cycle of once every 2 seconds. The flashing lasts for 10
seconds then stops.
1-4
3G Link
Figure 1-4. LED Indicators
Description
Indicates that the system is working normally.
Indicates a valid link on the WAN Ethernet port. Flashing indicates
network activity.
The Ethernet port has no valid link.
Indicates a valid link on the LAN Ethernet port. Flashing indicates
network activity.
The Ethernet port has no valid link.
Indicates the 802.11n radio is enabled. Flashing indicates wireless
network activity.
Indicates the 802.11n radio is disabled.
completed.
Indicates the WPS authentication of a device did not complete after 120
seconds.
Indicates that WPS is not in progress.
Indicates a connection through the attached 3G/3.5G USB modem.
Indicates that there is no connection or no attached 3G/3.5G device.