Installing Your New Unit; Basic Connections - JVC HR-XV3AA Instructions Manual

INSTALLING YOUR NEW UNIT

Basic Connections

Mains outlet
Mains power cord
DVD
Back of unit
To AV input
connectors
TV
TV aerial cable
AUDIO/VIDEO OUTPUT
INPUT
(L-1)
S VIDEO
Y
VIDEO VIDEO
P
B
AUDIO AUDIO AUDIO
P
R
OUTPUT
COMPONENT
OUTPUT
VIDEO OUT
DVD/VCR
DVD
ANTENNA IN
ANTENNA OUT
To aerial terminal
(provided)
It's essential that your unit be properly connected.
THESE STEPS MUST BE COMPLETED BEFORE ANY
VIDEO OPERATION CAN BE PERFORMED.
A
Check the contents.
Make sure the package contains all of the accessories
listed in "SPECIFICATIONS" on page 78.
B
Situate the unit.
Place the unit on a stable, horizontal surface.
C
Connect the unit to TV.
The connection method you use depends on the type of
TV you have.
RF Connection
8 To connect to a TV with NO AV input connectors —
A Disconnect the TV aerial cable from the TV.
B Connect the TV aerial cable to the ANTENNA IN
connector on the rear panel of the unit.
C Connect the provided RF cable between the
ANTENNA OUT connector on the rear panel of the
unit and the TV's aerial connector.
AV Connection
8 To connect to a TV with AV input connectors —
If your TV is equipped with a AV input connectors,
perform AV connection to improve picture quality during
tape playback.
A Connect the aerial, unit and TV as per "RF
Connection".
B Connect an optional AV cable between the AUDIO /
VIDEO OUT connectors on the rear panel of the unit
and the TV's AV input connectors.
D
Connect the unit to mains.
Plug the end of the mains power cord into a mains outlet.
After the connection is completed, perform "Video
Channel Set" on page 12.
9
EN