Child Lock; Scan Mode Set (Dvd Deck) - JVC HR-XV3AA Instructions Manual

66
EN
8 VIDEO STABILIZER — ON / OFF
When this function is set to "ON", you can automatically correct
vertical vibration in the picture when playing back unstable
recordings made on another recorder.
NOTES:
● When you finish viewing a tape, be sure to set this function to
"OFF".
● Regardless of the setting, this function has no effect during
recording and during special effects playback.
● The on-screen display may jitter vertically when this function
is set to "ON".
● To watch recordings with close-caption, set this function to
"OFF".
8 AUTO POWER OFF — 3H / OFF
When this function is set to "3H", the unit is turned off
automatically if no operation is done within 3 hours. "AUTO
POWER OFF IN 3 MIN" appears on the screen 3 minutes before
the unit is turned off.
SUBSIDIARY SETTINGS (cont.)

Child Lock

● Turn on the TV and select the video channel (or AV
mode).
● Slide the TV/VCR/DVD switch to the right.
You can disable the unit's operation.
A
Set the Child Lock.
Press and hold 1 on the remote control for more than
10 seconds while the unit is turned on. The unit turns off,
and "CL" appears on the front display panel.
● To release the child lock, press and hold
control until the unit turns on.
NOTES:
● When the child lock function is in use, keep the remote
control out of the children's reach.
● Timer recording programmes will be performed even if the
child lock function activated.
Scan Mode Set
(DVD deck)
● Turn on the TV and select the VCR channel (or AV
mode).
● Slide the TV/VCR/DVD switch to the right.
This unit supports the progressive scan system (eg. 480p*) as
well as the conventional interlaced scan system (eg. 480i*).
If your TV equipped with component video connectors, supports
the progressive video input, you can enjoy a high quality picture
by setting the progressive scan mode to active.
● Refer also the instruction manuals supplied with your TV.
● If your TV equipped with component video connectors does
not support the progressive video input, do not change the
scan mode to the "PROGRESSIVE".
* 480p and 480i indicate the number of scanning lines and scanning
format of an image signal.
● 480p indicates 480 scanning lines with progressive format.
● 480i indicates 480 scanning lines with interlaced format.
A
Switch the mode.
During playback or while stopped, press and hold DVD
on the Remote for more than 3 seconds, to change the
scan mode between Progressive and Interlace mode.
NOTES:
● It is not possible to change the scan mode when an MP3 or
JPEG disc is loaded.
on the remote
1