Advertisement
ASSEMBLY INSTRUCTION:
STEP 1:
A.) Push two Inner Caps (#33) into the Front Stabilizer (#4). Push two Rubber End Caps
(#32) into the Rear Stabilizer (#5).
B.) Attach a U-shaped Sleeve (#34) onto the bracket on the Front Stabilizer (#4). Make
sure the opening on the Sleeve is facing towards the front. Attach the Front Stabilizer
to the Front Vertical Frame (#3). Secure it with two M8 x 80mm Bolts (#20), four M 8
Washers (#30), and two M8 Nylon Locknuts (#27).
C.) Attach one U-shaped Sleeve (#34) to the bracket on the Rear Stabilizer (#5). Attach
the Back Support Frame (#2) to the Rear Stabilizer (#5). Secure it with two M8 x
80mm Bolts (#20), four M8 Washers (#30), and two M8 Nylon Locknuts (#27).
D.) Connect the Center Support Frame (#1) to the Back Support Frame (#2). Secure the
Lower hole with three M8 x 20mm Bolts (#22), six M8 Washers (#30), and three M8
Nylon Locknuts (#27).
E.) Connect the Center Support Frame (#1) to the Front Vertical Frame (#3). Secure the
lower hole with one M10 x 90mm Bolt (#18), two M10 Washers (#29), and one M10
Nylon Locknut (#26). Insert a L-shaped Lock Pin (#31) through the upper hole to lock
the Front Vertical Frame in position. Remove the Pin when folding the bench for
storage.
8
Advertisement
