Linksys CGV2W User Manual page 64

54Mbps 802.11g Wireless LAN Card
IMPORTANT NOTE:
End Product Labeling
Manual Information That Must be Included
56
In the event that these conditions can not be met (for example certain laptop configurations or
co-location with another transmitter), then the FCC authorization is no longer considered
valid and the FCC ID can not be used on the final product. In these circumstances, the OEM
integrator will be responsible for re-evaluating the end product (including the transmitter) and
obtaining a separate FCC authorization.
This transmitter module is authorized only for use in device where the antenna may be
installed such that 20 cm may be maintained between the antenna and users
This module will be bundling into Broadband product such as Wireless ADSL/Wireless
Router or AP/Wireless Cable Modem/ Notebook with antenna mounted around LCD
The final end product must be labeled in a visible area with the following:
ID: Q87-CGV2W".
The OEM integrator has to be aware not to provide information to the end user regarding how
to install or remove this RF module in the users manual of the end product which integrate
this module.
The users manual for OEM integrators must include the following information in a prominent
location " IMPORTANT NOTE: To comply with FCC RF exposure compliance requirements,
the antenna used for this transmitter must be installed to provide a separation distance of at
least 20 cm from all persons and must not be co-located or operating in conjunction with any
other antenna or transmitter.
(for example:
panel).
"Contains TX FCC