To Add, Reprogram Or Change A Keyless Entry Pin - Security + 3575C Owner's Manual

To Add, Reprogram or Change a Keyless Entry PIN

NOTE: Your new Keyless Entry must be programmed to operate your garage door opener.
USING THE "LEARN" BUTTON
1. Press and release the "learn"
button on motor unit. The learn
indicator light will glow steadily for
30 seconds.
2. Within 30 seconds, enter a four
digit personal identification number
(PIN) of your choice on the keypad.
Then press and hold the enter
button.
3. Release the button when the motor
unit lights blink. It has learned the
code. If light bulbs are not installed,
two clicks will be heard.
To change an existing, known PIN
If the existing PIN is known, it may be changed by one
person without using a ladder.
1. Press the four buttons for the present PIN, then press
and hold the # button.
The opener light will blink twice. Release the # button.
2. Press the new 4-digit PIN you have chosen, then
press ENTER.
The motor unit lights will blink once when the PIN has
been learned.
Test by pressing the new PIN, then press ENTER. The
door should move.
To set a temporary PIN
You may authorize access by visitors or service people
with a temporary 4-digit PIN. After a programmed number
of hours or number of openings, this temporary PIN
expires and will no longer open the door. It can be used to
close the door even after it has expired. To set a
temporary PIN:
1. Press the four buttons for your personal entry PIN (not
the last temporary PIN), then press and hold the ✽
button.
The opener light will blink three times. Release the
button.
One Button Close: Opener can be closed by pressing only the ENTER button if the one button close feature has been
activated. This feature has been activated at the factory. To activate or deactivate this feature press and hold buttons 1
and 9 for 10 seconds. The keypad will blink twice when the one button close is active. The keypad will blink four times
when one button close is deactivated.
USING THE SMART CONTROL PANEL™
9 1 9 1
7 3 7 3
5 KG KG 5
NOTE: This method requires two people if the Keyless
Entry is already mounted outside the garage.
1. Press the Prog <Learn> button on
2. Press the Prog <Learn> button
3. Enter a four digit personal
4. When the motor unit lights blink, it
2. Press the temporary 4-digit PIN you have chosen, then
3. To set the number of hours this temporary PIN will
3. To set the number of openings this temporary PIN will
The opener light will blink once when the temporary PIN
has been learned.
Test by pressing the four buttons for the temporary PIN,
then press ENTER. The door should move. If the
temporary PIN was set to a certain number of openings,
remember that the test has used up one opening.To clear
the temporary password, repeat steps 1-3, setting the
number of hours or times to 0 in step 3.
34
LO CK
LIG
HT
the Smart Control Panel™.
again to confirm Learn Mode.
identification number (PIN) of your
choice on the keypad. Then press
enter.
has learned the code. If light bulbs
are not installed, two clicks will be
heard.
press ENTER.
The opener light will blink four times.
work, press the number of hours (up to 255), then
press ✽.
work, press the number of times to open (up to 255),
then press #.
L O C
K
L O C
OR
L IG H T
K
T
L IG H