Electrolux EW7F4722NFB User Manual page 18

18 www.electrolux.com
for very delicate fabrics. The rinse
phase uses more water for some
washing programmes
• Night
comes on.
The intermediate and the final
spinning phases are suppressed and
the programme ends with water in the
drum. This helps to reduce creasing.
The door stays locked. The drum
turns regularly to reduce creasing.
You must drain the water to unlock
the door.
As the programme is very quiet, it is
suitable for use at night time when
cheaper electricity tariffs are
available. In some programmes the
rinses are performed with more water.
If you touch the Start/Pause
button, the appliance performs only
the draining phase.
The appliance empties the
water out automatically after
approximately 18 hours.
6.6 Prewash
With this option you can add a prewash
phase to a washing programme.
The corresponding indicator above the
touch button illuminates.
• Use this option to add a pre-wash
phase at 30 °C before the washing
phase.
This option is recommended for
heavily soiled laundry, especially if
containing sand, dust, mud and other
solid particles.
The options can increase the
programme duration.
6.7 Permanent Anti-stain
This option adds an anti-stain phase to
the programme. Use this option for
laundry with hard stains to remove.
To activate/deactivate this option, hold
the Prewash button pressed for 3
seconds until the indicator
goes off on the display.
. The related indicator
comes on/
Pour the stain remover into compartment
.
This option increases the
programme duration.
This option is not available
with a temperature lower
than 40 °C.
6.8 Permanent Soft Plus
Set this option to optimise the fabric
softener distribution and improve fabric
softness.
Recommended when you use fabric
softener.
This option increases the
programme duration.
The corresponding indicator above the
touch button illuminates and also stays
permanently on during next cycles until
this option is deactivated.
6.9 Permanent Extra Rinse
With this option you can permanently
have an extra rinse when you set a new
programme.
To activate/deactivate this option, hold
the Soft Plus button pressed for 3
seconds until the indicator
goes off on the display.
When it is activated, the appliance will
default to this option after you switch it
off or change/reset the programme.
This option increases the
programme duration.
6.10 Plus Steam
This option adds a steam phase followed
by a short anti-crease phase at the end
of the washing programme.
The steam phase reduces fabric
creasing and facilitates the fabric ironing.
The corresponding indicator above the
touch button illuminates.
The indicator is steady on during
steam phase.
comes on/