Table of Contents
Advertisement
CONTINUOUS DRAINAGE
Garden Hose Installation Setup
Water can be automatically emptied by attaching a hose to the continuous drainage port on the back of the de-
humidifier. This will allow the unit to run continuously (depending on the selected humidity level) without
having to empty the water bucket. To drain, simply attach a standard garden hose (not included). The thread
standard for garden hoses in the US and its territories is known as GHT or "garden hose thread" which has an
outer diameter of 1 1/16 inches (1.0625 inches or 27.0 mm) and a pitch of 11.5 TPI.
Place dehumidifier on a level surface.
•
Unscrew the cap on the back of the unit to access the garden hose nozzle.
•
Thread a garden hose (not supplied) onto the accessible nozzle, lead to a floor drain and cut to length.
•
Make sure that there are no kinks or knots in the garden hose. (See picture below)
•
Turn on the unit and press the MODE button until set to CONTINUOUS.
•
IMPORTANT NOTES:
Placing the dehumidifier on an uneven surface or improper hose installation may result in water filling up the
bucket and cause the unit to shut off. Empty bucket if shut-off occurs, then check dehumidifier location and
hose for proper setup. The bucket must be in place and securely seated for the dehumidifier to operate.
For more details, please scan below QR code for operation instruction video:
Garden Hose Installation Reference Guide
Advertisement
Table of Contents
