Chamberlain 3110C 1/3 HP Owner's Manual page 13

MOUNTING AND WIRING THE SAFETY
SENSORS
• Slide a 1/4"-20x1/2" carriage bolt head into the
slot on each sensor. Use wing nuts to fasten
sensors to brackets, with lenses pointing toward
each other across the door. Be sure the lens is not
obstructed by a bracket extension (Figure 5).
• Finger tighten the wing nuts.
Recommended Wire Routing
1. Using insulated staples, run the wires from both
sensors to the rail at the door header (Figure 6).
2. Cross and twist the two wires where they meet
the rail (see inset A). Run the wires inside the
channels at the top of the rail, along each side,
to the motor unit. Do not use the lower (trolley)
channels. Use a screwdriver tip to tuck the wires
snugly into the channels.
NOTE: If your access door is near the garage
door, you may choose to install the door control at
this time and run the door control wire along the
rail with the sensor wires. Use one rail channel for
the door control wire and the other channel for
both sensor wires. If you choose this option, follow
instructions 1-3 on page 16 now.
3. Pull wires taut across the top of the chassis and
insert into the opening above the terminal block
(see inset B). You will complete the wiring in
Installation Step 7.
B
Figure 5
Figure 6
1. Run wires from sensors to end of rail
at the door header. Cross & twist here to
help contain wires in channels on top of rail.
2. Run wires along channels
to motor unit. Use screwdrive blade
to tuck snugly into channels.
3. Pull wires taut across top of chassis
and insert into opening above
terminal block.
13
Carriage Bolt
1/4"-20x1/2"
HARDWARE SHOWN ACTUAL SIZE
Carriage Bolt
Wing Nut
1/4"-20x1/2"
1/4"-20
A
Sensor
Wire
Twist
Wires
Bell Wire
Sensor
Invisible Light Beam
Protection Area
Wing Nut
1/4"-20
Lens
Staples
Header
Wall
Sensor
Wire
Header
Bracket
Rail
Channel
Sensor