Table of Contents
Advertisement
en Troubleshooting
Fault
"E:36 / -25 / -26"
"E:35 / -10"
flashes.
flashes.
lights up.
flashes.
44
Cause
Drain pump is blocked.
The water pressure is low.
The filter in the water inflow
is blocked.
The tap is turned off.
The water inlet hose is
kinked or jammed.
There is water in the base
trough.
The appliance is leaking.
The automatic voltage con-
trol system detects an unau-
thorised voltage under-us-
age.
Voltage under-usage may
cause extension of a pro-
gramme.
Voltage under-usage may
cause extension of a pro-
gramme.
The temperature is too high.
Water level is too high.
Laundry is caught in the
door.
Door is not closed.
Troubleshooting
→ "Cleaning the drain pump",
▶
Page 39
No remedial action possible.
"Clean the water inflow filter"
▶
→ Page 42.
Turn on the tap.
▶
Ensure that the water inlet hose is
▶
not kinked or jammed.
Turn off the water tap.
▶
Call the after-sales service.
▶
→ "Customer Service", Page 53
Turn off the water tap.
▶
Call the after-sales service.
▶
→ "Customer Service", Page 53
No remedial action possible.
▶
Note: If the power supply is stable, the
programme continues to run as nor-
mal.
No remedial action possible.
No remedial action possible.
Wait until the temperature has
▶
dropped.
→ "Cancelling the programme",
▶
Page 34
Start the Abpumpen programme.
▶
Open the door again.
1.
Remove any trapped laundry.
2.
Close the door.
3.
Press Start/Nachlegen to start the
4.
programme.
Close the door.
1.
Press Start/Nachlegen to start the
2.
programme.
Advertisement
Table of Contents
