Hoover SmartWash+ FH52000 User Manual page 23

PROBLEM POSSIBLE CAUSE
Cleaner won't run 1. Not firmly plugged in
2. No voltage in wall plug
3. Blown fuse or tripped breaker
4. Fuse in cleaner blown
5. On/Off pedal not depressed
Low suction 1. Dirty Water Tank full/automatic shut off engaged
2. Blockage in tool on end of hose
3. Dirty Water Lid not on correctly
4. Dirty Water Tank Debris Filter clogged
5. Blockage in nozzle
6. Recovery Tank not properly secured
7. Recovery Nozzle not on correctly
8. Blockage in hose
Hose Nozzle stops spraying liquid during use 1. Clean Water Tank or Detergent Container is empty
2. Loose connection to solution port on foot of cleaner
Accessory Tool will not spray after filling the 1. Air is trapped in the hose & pump
Clean Water Tank or Solution Tank
Hose willl not spray after priming pump 1. Pump is defective
2. Not connected properly
Clean water won't dispense 1. Clean Water Tank or Solution Tank not firmly in place
2. Clean Water Tank or Solution Tank empty
Solution won't dispense 1. Unit is not moving in forward direction
Brushes won't rotate during floor cleaning 1. Brushroll stall protection activated
2. Unit in upright position
Water is Leaking out of Carpet Cleaner 1. Clean Water Tank, Solution Tank or Dirty Water Tank not
FIRMLY in place
POSSIBLE SOLUTION
1. Plug unit in firmly.
2. Check fuse or breaker in home.
3. Replace fuse or reset breaker in home.
4. Take to service center.
5. Press pedal.
1. Remove and empty Dirty Water Tank. See "How to Empty" page 13.
2. Remove tool and clear blockage.
3. Make sure lid is on securely. See "How to Clean" page 13.
4. See "How to Clean" page 13.
5. See "How to Clean" page 15.
6. Replace Recovery Tank and secure recovery tank latch.
7. Remove and replace Recovery Nozzle. See "How to Clean & Remove Nozzle" page 15.
8. Drop a coin through, clear with broom handle.
1. Turn off Cleaner and fill Clean Water tank & Detergent Container.
2. Check for secure connection to solution port on foot of Cleaner.
1. Turn on the Cleaner. If hose does not spray, prime the pump by lowering the hose down
to the floor and hold the trigger for up to one minute.
2. Aim downward & squeeze trigger.
1. Call for service: 1-800-944-9200.
2. Check connection.
1. Make sure tank is securely locked in position.
2. Refill container according to cleaning instructions.
1. Ensure unit is moving in forward direction.
1. Turn the unit off and back on, then inspect and clean for jams.
2. Brushes will not rotate in upright position. Step on handle release to start cleaning.
1. Make sure the tank is secure.
23