Watchguard Firebox M470 Hardware Manual page 23

Install the Firebox in the rack
Use these steps to complete installation of the Firebox in the rack. It could require two people to safely
complete these steps.
1. Stand in front of the rack and hold the Firebox with its front facing you.
2. Align the inner rails on each side of the Firebox with the outer rail on each side of the rack.
3. Slide the Firebox into the rack as far as possible.
4. Slide the blue slide rail locks on the inner rails toward the front and slide the Firebox completely into
the rack, until the front ear brackets touch the front of the rack.
5. You can use the larger screws included with the rack ears to attach the rack ear brackets to the rack.
Remove the Firebox from the rack
You must release the slide rail locks to remove the Firebox from the rack. It could require two people to remove
the device from the rack. The slide rail locks are blue tabs on the inner rails on each side of the Firebox.
To remove the Firebox from the rack:
1. Remove any screws that attach the mounting bracket to the front of the rack.
2. Gently pull the Firebox out about half way.
3. Slide the blue rail locks on the inner rails toward the front of the Firebox and pull the Firebox
completely out of the rack.
Hardware Guide
Hardware Installation
19