Watchguard Firebox M470 Hardware Manual page 22

Hardware Installation
Attach the inner rails and front ear brackets to the Firebox
Use these steps to attach the inner rails and front mounting brackets to the Firebox.
1. Locate the six short screws from the rail kit.
2. Put the inner rail against one side of the Firebox with the small blue release tab toward the front of the
Firebox, facing out.
3. Align the screw holes in the rail with the three screw holes on the side of the Firebox. The inner rail
extends out from the back of the Firebox.
4. Attach the inner bracket to the Firebox with three of the short screws provided in the rail kit.
5. Use two of the short screws included with the front ear brackets to attach an ear bracket to the front of
the Firebox on one side.
6. Repeat these steps to attach the other inner rail and ear bracket to the other side of the Firebox.
Attach the outer rails to the rack
You do not need to use screws to attach the rails to the network rack.
To attach rails to the rack, align the screw heads on each end of the rail
with holes in the rack and then latch the rail to the front and back of
the rack.
1. Align the front of one rail with three available screw holes in the
front edge of the rack.
2. Press the end of the rail toward the rack until the metal latch in
the center of the rail clicks into place around the inner edge of
the rack.
3. Align the rear of the outer rail with three available screw holes in
the rear of the rack.
4. Pull the latch handle slightly toward the center of the rack and
snap it into place around the inner edge of the rack.
5. Repeat these steps to install the second sliding rail in the rack.
Install alternate screws on the rails
If the screw heads on the rail ends are too large to fit through the
holes in your network rack, use the eight screws with smaller heads
(included with the rail kit) to replace the screws on the rails before
you install the rails in the rack.
1. Remove the outer two screws on the front of the rail
and replace them with two smaller screws included
with the rail kit.
2. Remove the two screws from the back of the rail and replace
them with two smaller screws included with the rail kit.
3. Repeat these steps to install smaller screws on the second rail.
4. Install the rails in the rack as described in the previous procedure.
18
Rear latch
handle
Remove and replace
Remove and replace
WatchGuard Firebox M370/470/570/670
Front latch