Connecting The Water Supply Hose - LG F L2CRV2 2 Series Owner's Manual

global_main.book.book Page 15 Wednesday, February 12, 2020 10:59 AM
4
Put the appliance on the anti-slip sheets.
• Do not attach the adhesive side
slip sheets to the feet of the appliance.
NOTE
• Additional anti-slip sheets are available at LG
Electronics service centre.
Connecting the Water
Supply Hose
Note for Connection
• Water pressure must be between 100 kPa and
1000 kPa (1.0‒10.0 kgf/cm²). If the water
pressure is more than 1000 kPa, a
decompression device should be installed.
• Periodically check the condition of the water
supply hose and replace the water supply hose if
necessary.
NOTE
• Do not overtighten the water supply hose or use
mechanical devices to tighten onto the inlet
valves.
• No further backflow protection required for
connection to the water inlet.
Checking the Rubber Seal
Two rubber seals are supplied with the water
a
supply hose. They are used to prevent water leaks.
Connection to taps is sufficiently tight.
• Do not use mechanical devices such as multi
grips to tighten the water supply hose. Ensure
that the curved end of the water supply hose is
connected to the appliance.
of anti-
a
Connecting the Hose to the
Water Tap
Connecting Screw-Type Hose to Tap with Thread
Screw the supply hose connector onto the water
supply tap.
Connecting Screw-Type Hose to Tap Without
Thread
1
Loose the 4 fixing screws
INSTALLATION 15 EN
.
a