Table of Contents
Advertisement
2
Select <DHCP>, and press
If you do not want to use DHCP/BOOTP/RARP to assign an IP address
●
Select <Off>, and press
the machine will waste time and communications resources searching the network for these services.
3
Check that <Auto IP> is set to <On>.
●
If <Off> is selected, change the setting to <On>.
4
Select <Apply>, and press
●
IP addresses assigned via DHCP override the address obtained via Auto IP.
Manually entering an IP address
1
Check that <Auto Acquire> is set to <Off>.
●
If <On> is displayed, select <Auto Acquire>, press
<Off>.
2
Select <Manually Acquire>, and press
3
Specify the IP address, subnet mask, and gateway address (or default gateway).
●
Specify the settings in the following order: <IP Address>
●
Enter each setting using the numeric keys, and press
5
Restart the machine.
●
Turn OFF the machine, wait for at least 10 seconds, and turn it back ON.
Checking whether the settings are correct
●
Make sure that the Remote UI screen can be displayed with your computer (
If a computer is not available, you can check the connection by using the operation panel (
Network Connection(P. 156) ).
Network
.
. If you select <DHCP> and press
.
.
155
when these services are unavailable,
, and set both <Select Protocol> and <Auto IP> to
<Subnet Mask>
<Gateway Address>.
.
Starting Remote UI(P. 270) ).
Testing the
Advertisement
Table of Contents
