Electrical Connection (4-Wire) - Viking CVER5301 Installation Manual

Electrical Connection (4-wire)

WARNING
Electrical shock hazard.
To avoid risk or electrical shock,
personal injury or death; grounding
product to the frame of the unit may
or may not be permitted through your local
codes. If ground to the frame is not permitted
then a 4 conductor power cord must be used.
See Electrical Requirements information.
Where local codes do not permit grounding through neutral, use a 4-wire power supply cord. The cord or
conduit must be secured to the range with the strain relief bracket.
The electrical connection is made at the terminal block, which is located behind the access door on the back
of the range.
1
Remove access door.
4
Feed supply cord up through hole in
bottom of range back.
grounded in accordance with local codes or in
absence of codes, with the National Electrical
Code (NEC). ANSI/NFPA 70-latest edition.
2
3
Remove supply cord strain relief
bracket and three supply cord mounting
screws on the terminal block.
5
1
Attach ground wire (green)
with ground screw that was removed.
12
WARNING
Electrical shock hazard.
To avoid risk of electrical shock,
personal injury or death; verify your
appliance has been properly
3
2
Remove grounding screw. Cut-off
and discard ground strap.
6
1
Attach line #1 (black) and line #2
(red) leads to outside terminal. Attach
neutral wire (white) to center terminal on
terminal block.