AEG LAVAMAT 12700 Instruction Booklet page 20

Something not working?
Problem
The water tap is closed (E10). Open the water tap.
The water inlet hose is
squashed or kinked (E10).
The machine does not fill
The small filter of the water
inlet hose is clogged (E10).
The door is not properly
closed (E40).
The end of the drain hose
The machine fills then
is too low.
empties immediately
The drain hose is
squashed or kinked (E20).
The drain filter or the
drain hose are clogged (E20). the hose.
The machine does not
The RINSE HOLD option
empty and/or does not spin
(stop with water in drum)
has been selected.
The laundry is not evenly
distributed inside the drum. manually in the drum.
Too much detergent has
been used.
An unsuitable detergent
has been used that
creates too much foam.
There is water on the floor
One of the connectors on
the water inlet hose is
leaking.
The drain filter has not
been properly screwed on
after cleaning.
38
Possible cause Solution
Check the whole length of the
hose and remove the kink.
Clean the filter.
Close the door.
Place the hose at the right
height (see Installation
section).
Check the whole length of
the hose and remove the
kink.
Clean the filter or check
Empty out the water by
pressing the START button
or selecting the DRAIN
programme.
Redistribute the laundry
Measure detergent
according to the
manufacturer's instructions.
Use a suitable washing
machine detergent.
Check that the hose is
firmly screwed on at both
ends.
Fully screw the filter into
place.
Problem Possible cause
The transit bolts have
not been removed.
The machine vibrates or is
noisy The feet have not been
adjusted.
There is little laundry in
the drum.
The programme is still
running and the drum
is turning.
The water level is above the
The door will not open bottom edge of the door.
The machine is heating the Wait until the end of the
water or draining the
clothes.
Something not working?
Solution
Check that the machine
has been unpacked as
described in the Installation
section.
Carefully level the machine.
Correct operation of the
machine is not affected.
Wait until the end of the
programme before opening
the door.
Before opening the door,
the water must be emptied
out.
heating or drying phase.
39