Emx66M Quick Guide; Connection - Yamaha powered mixer Owner's Manual

6

EMX66M Quick Guide

EMX66M Quick Guide
The following steps (1–5) explain the basic con-
nection and operation of the EMX66M.
Also, please read "Front and Rear Panel" and
"Basic Operation" following this Quick Guide
section to learn more about using the EMX66M.
STEP 1

Connection

Connecting speakers
Using speaker cables, connect each speaker to the
A 1 or 2 jack and to the B 1 or 2 jack in the
SPEAKERS jack section on the rear panel of the
EMX66M.
EMX66M
EMX66M
• You may connect to either of the two jacks on the
speakers.
• Be sure to use a cable designed for speaker connection.
Never connect the speakers in the manner shown
below. Otherwise, the EMX66M's built-in power
amplifier will be damaged.
EMX66M
EMX66M—Owner's Manual
SPEAKERS
SPEAKERS
B BRIDGE A
B BRIDGE A
2 1 2 1
2 1 2 1
SPEAKERS
BRIDGE
A
2 1
EMX66M
Setting the power amplifier mode
Set the power amp select switch (located on the
right corner on the panel) to MAIN-MAIN.
EMX66M
• This Quick Guide assumes that two main speakers
are connected. Refer to pages 16–17 for other con-
nections and power amp select switch settings.
Connecting a microphone
Make sure that the power is turned off to the
EMX66M.
Connect a microphone to the Low-Z jack of
channel 1–4.
EMX66M
Using a condenser microphone
Turn on the PHANTOM switch (located in the upper
right corner on the panel).
EMX66M
• Do not connect or disconnect a condenser micro-
phone while the power to the unit is on and the
PHANTOM switch has been turned on.
SPEAKERS
BRIDGE
B A
2 1 2 1
MAIN
MON
MAIN MAIN
MAIN
BRIDGE
Power amp select switch
Hi-Z Hi-Z
Hi-Z Hi-Z
Low - Z Low - Z
Low - Z Low - Z
Microphone
PHANTOM
ON
OFF
PHANTOM switch