Yamaha PDP-300 Owner's Manual page 5

5
• Short screws (black)
6
c
Attach the side panels (D) to the pedal
box (C).
Place the pedal box on top of the brackets attached to
the side panels (D), and attach using the four short large-
head black-colored screws.
v
Attach the center panel (B) to the side
panels (D).
The center panel (B) is installed between the side pan-
els (D) with the center lug on each end closer to the
pedal side of the pedal box. Each side of the center panel
is attached using two long black screws.
b
Install the main unit (A).
Place the main unit on the side panels (D) with the
screws on its bottom panel (toward the rear of the main
unit) just behind the grooves in the brackets located at
the top of the side panels (D), then slide the keyboard
forward until it stops.
Align the holes on the bottom panel of the main unit
(A) with the holes in the brackets on the side panels (D),
then screw in and securely tighten the four short black-
colored screws.
A
A
B
C
D
D
D
E
E
• Cord holders
• Insert the screws extending from
the bottom of the main unit into
the bracket grooves.
7
• Rotate the adjuster unit it coms
in firm contact with the floor
surface.
n
Connect the pedal cords.
Attach the pedal cord to the two pedal cord holders lo-
cated on the side panel, then insert the pedal cord plug
into the connector located at the bottom of the main
unit's rear panel, making sure that the tab on the plug
faces forward.
* Check to make sure that all screws have been securely
tightened.
m
Be sure to set the adjuster.
For stability, an adjuster is provided on the bottom of
the pedal box (C). Rotate the adjuster until it comes in
firm contact with the floor surface. The adjuster ensures
stable pedal operation and facilitates pedal effect control.
* If the adjuster is not in firm contact with the floor surface,
distorted sound may result.
3