Yamaha mLAN MLAN8P Owner's Manual page 25

[Audio In Plug]
Select an input "Plug" for connection from the mLAN Plugs (virtual plugs) on the selected
device. If the device does not have an appropriate mLAN Plug, "No Source (Destination)
Plug" appears.
This screen does not appear for [Mixer 2] channels [9] - [12] (Digital In, A/D In).
A5000's "Assignable 1" is connected.
No appropriate Plug was found.
[Link (Link Switch)]
When this parameter is turned on, all channels are paired using combinations of 1&2, 3&4,
5&6, 7&8, 9&10, and 11&12. Both channels of each pair will have the same parameter set-
tings, except for the [Input Device/Nickname] and [Audio In Plug] parameters.
Value: On, Off
NOTE
The parameter value of the channel for which the Link Switch is turned on
will be applied to both channels. When the Link Switch is On, the Pan param-
eter changes to the Balance parameter.
[Gain]
This parameter enables you to adjust the input signal level in 6dB steps.
Value: –6dB, 0dB, +6dB, +12dB, +18dB, +24dB
Mode Functions
25