Eliminating Minor Faults Yourself - Siemens KF R Series Instructions For Use Manual

en

Eliminating minor faults yourself

Before you call customer service:
Please check whether you can eliminate the fault yourself based on the following
information.
Customer service will charge you for advice – even if the appliance is still under
guarantee!
Fault
Temperature differs
greatly from the set
value.
The light does not
work.
Bottom of the
refrigerator
compartment is wet.
The temperature in the
refrigerator
compartment is too
cold.
28
Possible cause
The bulb is defective.
Light switch is
jammed.
The condensation
channel or drainage
hole are blocked.
Temperature has been
set too low.
Remedial action
In some cases it is adequate to
switch off the appliance for
5 minutes.
If the temperature is too high wait a
few hours and check whether the
temperature has approached the set
value.
If the temperature is too low check
the temperature again the next day.
Replace bulb. Fig. ,/B
1. Switch the appliance off.
2. Pull out mains plug or switch off
fuse.
3. Remove bulb cover from the rear.
4. Change the bulb.
(Replacement bulb:
220-240 V a.c., E14 bulb holder,
see defective bulb for wattage.)
Check whether it can be moved.
Fig. ,/A
Clean the condensation channel
and the drainage hole. See chapter
Cleaning the appliance. Fig. +
Increase the temperature.