Table of Contents
Advertisement
SC-F10000H Series/SC-F10000 Series
J
While lifting the right lift lever, firmly insert the
media holder onto the roll core of the media.
Note:
If the roll of media has an outer diameter that is less
than 140 mm (5.51 in.), the roll core will not reach
the media holder when raised using the lift lever.
Raise it with your hands, and insert the roll core
into the media holder.
K
To ensure that the media holder is sufficiently
inserted into the roll core, push the top of the
media holder towards the end of the roll two
times.
c
Important:
If the media holder is inserted into the roll core
insufficiently, media is not fed correctly during
printing because of slippage between the media
holder and roll core.
This may cause banding in the print results.
User's Guide
Basic Operations
L
M
72
While pressing from the top of the media holder,
tighten the fixing screw until it no longer turns.
Tighten it so the media holder does not move.
c
Important:
If the media holder screw is loose, the media
holder may move during printing. This could
cause stripes and unevenness in the print
results.
Rotate the handle until part A in the illustration
below is fully inserted.
c
Important:
Once part A is hidden, do not turn the handle
any further. Failure to observe this precaution
could damage the media holder.
If part A is still visible even after the handle has
been turned fully, rewind the handle. Loosen
the media holder screw on the right side, and
then restart from Step 5.
Advertisement
Table of Contents
