Table of Contents
Advertisement
JHD40BT
TUNER OPERATION
5
1
1/
VOL +
UP
17
MUTE
SEEK
INFO
2/
RPT
/TUNE
ENTER
AUDIO
/TRK
3
MENU
DOWN
3/
INT
VOL -
BAND
16
SEARCH
2a
6
7
13
2b
Select a Band
Press the BAND/SEARCH button (16) to change between three FM bands and two AM (MW)
bands.
Manual Tuning
Press the SEEK/TUNE/TRK |<< or >>| buttons (13, 14) to seek stations up/down step by step.
Auto Seek Tuning
Press and hold the SEEK/TUNE/TRK |<< or >>| buttons (13, 14) to automatically seek the next
or previous strong station.
Preset Stations
Six numbered preset buttons store and recall stations for each band.
Store a Station
Select a band (if needed), then select a station. Press and hold a preset button (5-10) for two
seconds. The preset number will appear in the display.
Recall a Station
Select a band (if needed). Press a preset button (5-10) to select the corresponding stored
station.
20
JHD40BT
8
DISP
12
SCROLL
4/
RDM
EQ
11
LOUD
SEEK
5/
/TUNE
/TRK
15
AS/PS
6/
4
MODE
18 14
10
9
19
Automatically Store / Preset Scan (AS/PS
Automatically Store
Select an AM or FM band. Press and hold the AS/PS
seconds to automatically select strong stations and store them in all bands. The new stations
replace any stations already stored in that band.
NOTE: During Auto Store (AS), the tuner will default to "Local" mode while scanning the
band initially. After scanning the entire band once, the unit will switch to "Distant" mode
for all subsequent Auto Store tuning.
Preset Scan
Select a band (if needed). Press the AS/PS
The unit will pause for ten seconds at each preset station. Press AS/PS
scanning when the desired station is reached.
7
)
button (15) for more than three
button (15) to scan stations stored in all bands.
again to stop
Advertisement
Table of Contents
