California Energy Commission Battery Charging Testing; Instructions - AT&T CL80067 User Manual

Appendix
California Energy Commission battery charging
testing instructions
This telephone is set up to comply with the energy-conserving standards right out of the box.
These instructions are intended for California Energy Commission (CEC) compliance testing
only. When the CEC battery charging testing mode is activated, all telephone functions, except
battery charging, will be disabled. (For
CL84347/CL84357/CL84367, only the telephone functions on the cordless handsets will be
disabled.)
When first purchased and properly installed for charging (see Battery installation and
charging on pages 7-9), put the handset in the handset charger to charge. The CEC battery
charging testing mode is activated while charging.
If you have registered the handset to the CL82107/CL82207/CL82257/CL82267/CL82307/
CL82357/CL82367/CL82407/CL82467/CL82507/CL82547/CL82557/CL83107/CL83207/
CL83307/CL83407 base, below are the testing instructions.
To activate the CEC battery charging testing mode:
1. Unplug the telephone base power adapter from the power outlet. Make sure all
handsets are inserted with charged batteries before proceeding.
2. While you press and hold
the power outlet.
3. After about 20 seconds, when the IN USE light starts flashing, release
then press it again within two seconds.
When the phone successfully enters the CEC battery charging testing mode,
the IN USE light turns off and all handsets display To register HS, see manual.
When the phone fails to enter this mode, repeat all the steps mentioned above.
To deactivate the CEC battery charging testing mode:
1. Unplug the telephone base power adapter from the power outlet, then plug it back in.
The telephone base is powered up as normal.
2. Register your handsets back to the telephone base. See pages 10-11 for handset
registration instructions.
If you have registered the handset to the CL84107/CL84207/CL84257/CL84307/CL84327/
CL84347/CL84357/CL84367 base, below are the testing instructions.
To activate the CEC battery charging testing mode:
1. When the telephone base is in idle mode, press and hold
2. After about 10 seconds, when the IN USE light starts flashing and the screen displays
Deregister all devices?, release
/SELECT within two seconds.
MENU
When the phone successfully enters the CEC battery charging testing mode,
the IN USE light turns off and all handsets display To register HS, see manual.
When the phone fails to enter this mode, repeat all the steps mentioned above.
To deactivate the CEC battery charging testing mode:
1. Unplug the telephone base power adapter from the power outlet, then plug it back in.
The telephone base is powered up as normal.
2. Register your handsets back to the telephone base. See page 12 for handset
registration instructions.
CL84107/CL84207/CL84257/CL84307/CL84327/
/FIND HS, plug the telephone base power adapter back to
/FIND HS, and then press it again or press
34
/FIND HS, and
/FIND HS.