Hoshizaki KM-350MWJ Service Manual page 25

2. Bin Control Adjustment
• All parts are factory-adjusted. Improper adjustments may adversely affect safety,
performance, component life, and warranty coverage.
• In Hoshizaki DB and DM dispenser applications, the bin control controller setting
must be adjusted to 2. For Coca-Cola Freestyle® Dispenser and non-Hoshizaki
dispenser applications, the bin control controller setting must be adjusted to 3.
Increasing the ice level on any dispenser application could lead to icemaker
movement, water leakage, or ice overflow.
• Do not block the bin control lens with top kits or the icemaker will not operate
properly.
• Failure to properly adjust the bin control setting could result in water leakage, ice
backup, and icemaker damage.
The bin control is factory set to 1 for use on Hoshizaki America standard ice storage bins.
See the table below for adjustments to ice level.
WARNING! Do not adjust outside of these settings.
1) If not already removed, remove the front, top, and right side panels.
2) Confirm bin control controller setting for proper application. See the table below for
settings. See Fig. 4 for ice level reference.
Application
Default: Standard Ice Storage Bins
Hoshizaki DB and DM Dispensers
Coca-Cola Freestyle
®
Non-Hoshizki Dispensers
Optional Settings
Recommended Setting for
Hoshizaki DB or DM Dispenser
Factory Default for
Standard Ice Storage Bins
Bin Control
Controller
Dispenser and
Recommended Setting for
Coca-Cola Freestyle
and Non-Hoshizaki Dispensers
Model Shown:
KM-660MAJ with B-300SF
WARNING
NOTICE
Bin Control Ice Level Settings
Bin Control Controller
Setting
1
2
3
4
5
Dispenser
®
Fig. 4
25
Ice Detection Distance From
Bin Control Lens
254 mm (10")
305 mm (12")
406 mm (16")
508 mm (20")
610 mm (24")
Bin Control
Setting #1
Setting #2
Setting #3
Setting #4
Setting #5
Lens