Cabinet Installation; Model And Serial Number Location - Frigidaire FFEW2426US Installation Instructions Manual

ELECTRIC WALL OVEN INSTALLATION INSTRUCTIONS
If oven is used in a new branch circuit installation
(1996 NEC), mobile home, recreational vehicle, or
where local codes DO NOT permit grounding through
the neutral (white) wire, the appliance frame MUST
NOT be connected to the neutral wire of the 4-wire
electrical system. (see figure 3):
1. Disconnect the power supply.
2. Separate the green (or bare copper) and white
appliance cable wires.
3. In the junction box:
connect appliance and power supply cable wires as
shown in Figure 3.
Cable from Power Supply
Ground Wire
Red
Wires
Ground Wire
(Bare or Green
Wire)
Junction Box
Cable from appliance
Figure 3
4-WIRE GROUNDED JUNCTION BOX

Model and Serial Number Location

The serial plate is located along the interior side trim of
the oven and visible when the door is opened.
When ordering parts for or making inquires about your
oven, always be sure to include the model and serial
numbers and a lot number or letter from the serial plate
on your oven.
Single Wall Oven
Serial Plate Location

5. Cabinet Installation

White Wire
1
Black
2
Wires
3
White Wire
U.L.-Listed
Conduit Connector
4
(or CSA listed)
5
4
IMPORTANT!
Do not lift or manipulate the oven by the door handle
or the control panel.
Heavy Weight Hazard
• Use 2 or more people to move and install wall oven.
• Failure to follow this instruction can result in injury or
damage to the unit.
• Oven doors may be removed to aid installation. See
Use and Care Guide for door removal instructions.
Unpack the wall oven. Remove the bottom trim
taped on the oven top panel.
Find the 2 anti-tip mounting screws included in the
literature package.
Insert the oven into the cabinet opening. Slide
oven inward leaving 1½" (3.8 cm) clearance
between the oven and front of cabinet (see
Figure 4).
Pull the armored cable through the hole for it in the
cabinet and toward the junction box while moving
the appliance inward.
Push the oven in and against the cabinet.
Figure 4
1½" (3.8 cm)
clearance
between unit
and front of
cabinet