Table of Contents
Advertisement
3
Insert the Battery Holder into the Remote
Controller.
≥When the button-type battery is exhausted,
replace it with a new CR2025 battery. (A battery
is normally expected to last about 1 year.
However, it depends on operation frequency.)
≥Make sure to match the poles correctly when
inserting the battery.
CAUTION
Danger of explosion if battery is incorrectly
replaced. Replace only with the same or
equivalent type recommended by the
equipment manufacturer. Discard used
batteries according to manufacturer's
instructions.
WARNING
Risk of fire, explosion and burns. Do not
recharge, disassemble, heat above 100xC or
incinerate. Keep the Button-Type battery out
of the reach of children. Never put
Button-Type battery in mouth. If swallowed
call your doctor.
ª Using the Remote Controller
1
Direct the Remote Controller at the Remote
(36)
Control Sensor
and press an appropriate button.
10˚
15˚
15˚
≥Distance from the Movie Camera: Within
approximately 5 metres
≥Angle: Within approximately 10o in the
upward, and 15o in the downward and
horizontal directions from the central axis
≥The above operating ranges are for indoor use.
Outdoors or under strong light, the Movie
Camera may not operate properly even within
the above ranges.
≥Within a 1-metre range, you can also use the
Remote Controller on the LCD Monitor side of
the Movie Camera.
68
Before Use
of the Movie Camera
(36)
15˚
Selecting Remote Controller Modes
When 2 Movie Cameras are used
simultaneously, they can be operated individually
by selecting different Remote Controller Modes.
≥If the Remote Controller Mode of the Movie
Camera and that of the Remote Controller do
not match, [REMOTE] Indication is displayed.
Setup on the Movie Camera:
Set [REMOTE] on the [INITIAL] Sub-Menu to the
desired Remote Controller Mode. (
Setup on the Remote Controller:
6
1
STILL ADV
PAUSE STILL ADV
2
E
;
INDEX
STOP
K
∫
SELECT
[VCR1]: Press the [D] Button and [∫] Button
simultaneously. 1
[VCR2]: Press the [E] Button and [∫] Button
simultaneously. 2
≥When the battery in the Remote Controller is
replaced, the mode is automatically reset to
[VCR1] Mode.
Power Supply
ª Using the AC Adaptor
1
Connect the DC Input Lead to the Movie
Camera.
2
Connect the DC Input Lead to the AC
Adaptor.
3
Connect the AC Mains Lead to the AC
Adaptor and the AC mains socket.
≥The AC Mains Lead's outlet plug does not fit
entirely into the AC Adaptor socket. A gap will
remain as shown 1.
≥Before connecting or disconnecting the
power supply, set the [OFF/ON] Switch on
the Movie Camera to [OFF] and make sure
that Power Lamp is not lit.
)
-76-
W
5
1
D
INDEX
P.B. ZOOM
L
1
Advertisement
Table of Contents
