Replacing The Filters; Filter Replacement Indicator - Philips AC2889/10R1 User Manual

5
Allow the pre-filter to air dry
thoroughly before placing back in
the air purifier.
Note
• To optimize the lifetime of the
pre-filter, make sure it air dries
completely after cleaning.
• Wash your hands after handling the
filter.
6
Put the pre-filter back into the air
purifier (fig. h).
Note
• Make sure the side with the two
clips is pointing towards you, and
that all hooks of the pre-filter are
properly attached to the air purifier.
7
To reattach the front panel, press
the top part of the panel onto the
top of the air purifier (1). Then, gently
push the panel against the body of
the air purifier (2) (fig. i).
8
Put the plug of the air purifier in the
wall outlet.
9
Touch and hold the reset button
for 3 seconds to reset the pre-filter
cleaning time (fig. {).
10
Wash your hands thoroughly after
installing filters.
6 Replacing the
filters
Filter replacement
indicator
This air purifier is equipped with a
filter replacement indicator to make
sure that the air purification filter is in
optimal condition when the air purifier
is operating. When the filters need to be
replaced, the filter code displays on the
screen (see Filter alert chart).
If the filters are not replaced in time,
the air purifier will stop operating and
automatically lock to protect the air
quality in the room. Replace the filters
as soon as possible according to the
filter code.

Replacing the filters

Note
• The air purification filters are not
washable nor vacuum cleanable.
• Always turn off the air purifier and
unplug from the electrical outlet
before replacing the filters.
• Do not clean the filters with a
vacuum.
• If the pre-filter is damaged, worn or
broken, do not use. Visit
www.philips.com/support or contact
the Consumer Care Center in your
country.
EN 11